1/2/2024 0 Comments Piezo ignitor electrode![]() ![]() If the dial or readout doesn’t change, this indicates no continuity, and the igniter needs to be replaced. If the meter reads between 50 and 400 ohms of resistance, on either type of multimeter, the igniter has continuity. Touch one multimeter probe to each terminal on the igniter. How do you test an igniter with a multimeter? The spark ignites the gas coming from the burners. They just make a spark, like a long gas lighter that has run our of gas. NO, igniters don’t have batteries, as with all grill igniters. The lighter is wired in such a way that this whole voltage is applied in a small region of air gap between two metallic points. How many volts does a piezo igniter produce?ĭue to piezo-electric effect, a high voltage is generated in the range of 800 volts. Do piezo igniters go bad?ĭo piezo igniters wear out? Piezoelectric igniters will never wear out, so long as the quartz crystal inside does not shatter, or the hammer mechanism breaks in some way, etc. If a spark is present every time the igniter is pressed, the piezo igniter is fine, if no spark is seen, replace the piezo igniter. Note: Goods offered for sale by Gameco are not for use on hot air balloons or aircraft.Connect the piezo igniter to the electrode (figure 3), holding the electrode about ¼” to ½” away from the shell of the heater with the insulated pliers depress the piezo igniter. All equipment must be replaced within the manufacturer’s recommended service life. See and abide by all Safety Warnings available from the statutory authority, equipment manufacturer and gas supplier. Remember to instruct the owner/user/customer in safety and maintenance matters concerning the gas and equipment. Ensure the valves and the equipment you install are the proper ones for the installation. ![]() Some Australian Standards may be the law in your state or territory,Īll persons employed in handling Gases must be trained in proper handling and operating procedures. Check with the gas supplier and local statutory authority for any further material. Always refer to the specific instructions and warnings for all equipment. ![]() Gameco recommends that you become thoroughly familiar with all the relevant Australian Standards and Codes. In your state or territory you may need to be licenced to carry out work on Gas Installations – check with your local authority. Improper conditions or procedures can cause accidents, which may result in property damage and personal injury. Make sure you are thoroughly trained before you attempt any Gas Installation, maintenance or repair. ![]() To avoid serious injury and property damage – please note:Įvacuate the area immediately and call your local fire authority Natural gas and LP gas are extremely flammable and explosive. The products Gameco offers for sale are for use on combustible and other dangerous gases. All sales are subject to Gameco’s General Terms and Conditions of Sale. We, therefore, advise that all components and parts sold by Gameco Pty Ltd are conditional on the appropriate regulations being met. Government regulations require all gas installations to be certified by Licenced Gas Installers, and cylinder valves and components to be fitted by SAA approved Gas Cylinder Test Stations. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |